Printed silver electrodes detected touch through an insulating laminate.
Two silver electrode patterns were printed on Tangho NanoPaper™ and covered with an insulating laminate. Connected to a readout, the construction detected a finger touching the laminate above the printed electrodes.
The 12-minute profile belongs to this particular demonstration. The current TDS gives the general silver-ink processing example of 150 °C for 30 minutes; it remains the reference for published material guidance.
The clip demonstrates touch detection through the insulating layer. It does not measure calibrated sensitivity, response time or cycle life.
Electrode geometry, overlay thickness, connections and readout settings determine the complete interface response. For a product-specific evaluation, choose the required touch area and overlay, then check repeatability, bending, humidity exposure and repeated use. Inspect laminate adhesion and the printed-to-electronic connections along with the touch response.
Plan your own direct ink writing trial. For more about this demonstration, see the Voltera webinar recap.
Share a short, non-confidential summary of the application you have in mind.
Discuss your application · Technical data sheets